The powder mixer is a kind of machine that mixes several kinds of powder materials, which provides great convenience for people's lives. But there are various kinds of mixing machines in the market. What methods should we use to distinguish the material mixing quality of the powder mixer?

Mixing uniformity

Judging whether the powder mixer mixture is good or bad, firstly, it can be observed from the aspect of mixing uniformity of the material to determine whether the uniformity meets its own needs. However, if the mixture is too much, the uniformity of all materials cannot be checked. We can detect a part of the material and then obtain the probability calculation.

For example, mixing several kinds of materials of ten cubic meters, because of the large volume, it is difficult to detect the uniformity of all materials. This is that we can take one cubic meter of material, test the mixing uniformity, and then calculate the probability. , analog to all materials, very convenient and fast.

2. Mixed corners

A mixed dead angle is the part of a material that cannot participate in mixing when it is mixed in a mixer. Most of this temperature occurs because of structural problems in its own design, which causes a part of the material to be squeezed at the dead corner. Sometimes, due to the long-term use of the equipment, the parts are aged and the work efficiency is lowered, and such problems may occur.

Therefore, it is a good method to check the mixing effect of the materials in the mixer. It is a good method to check the mixing angle of the material in the total material. The mixing efficiency of the mixer can be visually observed.

3. Mixing time

Mixing time refers to the time required for the mixer equipment to mix the materials to the required mixture, as the length of the mixing time directly affects the operating efficiency of the equipment.

However, the mixing time cannot be viewed in a narrow sense. As long as the mixing time of the equipment is short, it must be efficient. We also need to look at the mixing quality of the materials. It should be the time required by the mixer when the mixing quality of the same material can be achieved. In this case, the mixing time is short and the mixing efficiency of the equipment is high.

In the above, we introduced the method of mixing the quality of the powder mixer, which is mainly identified by the three aspects of mixing uniformity, mixing time and mixing dead angle. If you have any questions about this, please feel free to contact us and we will try our best to give you a satisfactory answer.